Here are the two bolts in the trunk area. As you can see, the sheet metal is quite well supported by the bulkhead here. I used large grade 8 washers to spread the load a little.
The pedal position turned out EXACTLY where I wanted it. I used the M3 as a reference so I think it should work our really well.
I may have to grind a little off of the side of the brake pedal. I have wide feet, and there is very little room between the brake pedal and the shifter hump. Just trimming off the right side of the brake pedal should allow adequate clearance for the throttle pedal and should make for great heel/toe action. The guy that is making my throttle pedal it heading to the Daytona 24hr race, so that will be a little bit before it gets here.
Jason