Thread: Unable to start
View Single Post
  #3  
Old March 2nd 2011, 08:18
evilC's Avatar
evilC evilC is offline
Registered User
 
Join Date: Jun 2008
Location: UK Where Leics is more
Posts: 644
Doesn't the wiring loom travel down the A pillar and then along the heater channel flange to the rear/ It does on our RHD 1303. It may be that the welder moved the lom out of the sill area but melted the wiring in the door post. Its worth a check. I bet he would have ensured that the horizontal part of the loom was far enough away from any heat - wouldn't he?

Clive
Reply With Quote