Thanks for the reply.
I looked at the mounting options for the turbo a little closer and it will fit much better if the oil drain line is not 100% vertical. Can I get away with mounting the drain at about a 30* angle from the horizontal .... the oil will be draining down at a 30* angle instead of straight downword at a 90* angle.
If this is acceptable, then the outlet of the header is a direct straight shot into the turbo inlet
I can't rotate the exhaust housing to compensate for the drain as the drain is part of the exhaust housing. The compressor can be rotated but this does not help the angle.
I hope I am being clear on this
Sandeep