[Thorkhild]

I'm putting one on my type 3. I'm going to use mostly type 3 and 4 FI parts.

My intake manifolds are a combination of stock type 3 end castings grafted to stock carb manifolds. (cut the runners off the fi setup, and the bottom of the carb manifold) This gives me a good mounting for the injectors.

Going to use the stock pdsit carbs as throttlebodies. The system will look like a stock carb system with injectors.

I've got the ecu built, and will start working on the wire harness.

Where are you guys going to mount the ECU?