View Single Post
  #5  
Old November 1st 2006, 23:33
MikeVW's Avatar
MikeVW MikeVW is offline
Registered User
 
Join Date: Dec 2005
Location: Sacto
Posts: 70
You could make your own die. Use hard wood and make a male and female piece with the taper in it. Drill the hole to the size you want and then put the male end on the outside and the female on the inside and tap with a hammer. Give it a shot on a piece of scrap first!

Mike
__________________
Jack of all trades and master of none!

http://www.Type1R.com
Reply With Quote