A few days ago, I took the engine and the tranny off, as I'm not going to drive the car during the winter, so this gives me time to try and install the 915 gearbox.
I'm trying to do this on a budget, so I'm going to use what I already have, as much as I can.
The clutch part is a puzzle, and I'm lucky with all the info on this forum, otherwise I wouldn't have had the courage to take on a project like this.
So, this is what I already had: A 915 pressure plate, a 915 good used disc, a bus 228mm flywheel, pressure plate and disc.
The bus disc is useless ofc, and I tried the 915 disc in the 228mm bus pressure plate but it will never fit.
Today I sourced one of those Lancia 228mm discs that have been discussed about here, and it seems perfect. I alligned it's center with the porsche one, and it's a perfect match. Haven't tried it on the gearbox yet. Oh, and it fits inside the 228mm sachs pp
I also welded and redrilled the 915 flanges for the 944 drive axles.
also, the new wheels and the topline strut brace are in
