View Single Post
  #33  
Old December 14th 2009, 05:08
vugbug71's Avatar
vugbug71 vugbug71 is offline
Registered User
 
Join Date: Dec 2009
Location: sactown/placerville, CA
Posts: 22
And Thanks to Clive for the excellent info. That is pretty much what i had in mind, there is no back seat in this so that wont be a problem. I think i'm going to weld a cross tube in the middle of the roll bar and then weld tubes to where the heater tubes would be (under the back seat area) going down diagnally from the cross bar.
Reply With Quote