Hi Rich
Lots of bracing and I can double up on the tubes if needed.
been getting a bit done on the chassis. I'm going to lay my shocks a little further forwards to give more axle clearance.
I'm really happy with the tube bender and notcher that I bought from Affordable benders, really nice bend with no kinks. I made the first bit to go over the transmission and allow the torsion bar inner spline area to be removed.
I made an extra base for the hoop using 50x50 tube, I made it into a U channel and I was having difficulty cutting a hole with the notcher until I welded a length of angle to it
welded the hoop to torsion bar housing and added an extra bit at the base