View Single Post
  #806  
Old May 15th 2011, 08:13
Wally's Avatar
Wally Wally is offline
Registered User
 
Join Date: Nov 2002
Location: The Netherlands
Posts: 2,552
This is what happens if you run into the 'hard-cut' rev limiter:



Some of you may recognise this phenomenon from my previous encounter with the hard-cut; yes, this already happenend before...
This time I wanted to test flat-foot-shifting, so soft-cut was lowered a lot and hard-cut set at the same rpm distance from the soft-cut, about 600 rpm.

This will never happen again now, as I will now set the hard-cut 2000 rpm or more away from the soft-cut. The cure is apperently worse then the problem it tries to prevent...
Reply With Quote