|
|
#1
February 21st 2003, 22:52
|
|||
|
|||
|
Linkage for Upright kit and Webers
I was curious if there was a special type of linkage I need to use with the Sharpbuilt upright kit for my type4 engine, I have weber40's and no linkage yet, any suggestions? or can I just use like some scat hex linkage and be done? Thanks
__________________
Lowered 66' 13 window bus, with a typeIV 2 Litre, next step 944 disks all around + cookie cutters 
|
|
#2
February 22nd 2003, 06:43
|
|||
|
|||
|
On this page, http://www.germanlook.com/Forums/sho...threadid=1286, there is a brief discussion over the matter. If you want to skip that, its says a bell crank linkage is best for a few reasons one being that the hex bar linkage has to be modified to fit.
|
|
#3
February 23rd 2003, 23:15
|
|||
|
|||
|
hey thanks allot tito, i thought i thought i scanned all the posts making sure there wasnt already a discussion on this, but i must have missed it, thanks allot for your help.
__________________
Lowered 66' 13 window bus, with a typeIV 2 Litre, next step 944 disks all around + cookie cutters
|
 |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
