|
|
#1
August 1st 2006, 11:59
|
|||
|
|||
|
Shop cleanup.....Parts FS
I'm trying to get sell off some stuff because it's getting a little hard to walk around the shop without tripping...
86T (Low offset) 944 alum arms, with hub and ebrake stuff (shoes, hardware) $C300, no calipers or disk. 944 Stub axles (T1 splines, with 100mm joints) $C80 pr 944 spindles (Early and late NA), $C40/pr Rear 944 brake setups (backing plate, hub, ebrake hardware, NA calipers) $C335 (IRS), $C350 (SwingAxle). Lanner Last edited by flat; August 24th 2006 at 15:05. 
|
|
#2
August 10th 2006, 15:20
|
|||
|
|||
|
Open to offers....(reasonable ofcourse).
L
|
|
#3
August 14th 2006, 14:42
|
|||
|
|||
|
944 Master cylinders..$C100ea
944 front brake caliper NA with pads $C210pr Last edited by flat; August 24th 2006 at 15:06.
|
|
#4
August 16th 2006, 07:54
|
|||
|
|||
|
More stuff...
MK4 1.8T passenger strut (complete) $C40 73-39 Bus front calipers (with almost new pads) and rotors (pr of each) $C40 Super beetle disk brackets (for KG brakes), not mine but from a CIP kit..$C40 Single Dellorto 40 on DP middle manifold. No filter of throttle cable $C210 Blank fron KG rotors (NEW) $C100 pr. Drilled to any pattern and studded M12 $C150. (M14 studs extra) Easy, Lanner Last edited by flat; August 24th 2006 at 15:06.
|
|
#5
August 24th 2006, 15:08
|
|||
|
|||
|
Edit on prices above...
Also, Audi TT billet hubs and brackets for CD dropped drums spindle, cosmetically challenged, $C400set. Uses 312x25 rotors and mk4vr6/1.8T calipers. Same as above but for A3 VR6 rotor (288x25), $375set. Lanner
|
|
#6
August 30th 2006, 07:48
|
|||
|
|||
|
Complete 944 steel IRS arms with stub axle, all NA brakes (except rotor).
$C400pr.
|
 |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
