F/S - Kennedy Eng flywheel T-4 Conversion

[DORIGTT]

Have a look at this BEAUTIFUL piece of machining

Kennedy Engineering flywheel was purchased for a T-4 to T-1 conversion. I'm going another route so here it is on the chopping block.

The hardware and pilot bearing are included.

Purchased for $ 250 new. Paypal me $ 125 plus shipping and it's yours!

Thanks for shopping in my garage.

[DORIGTT]

O.K. O.K. I know you all want this....I'll change the price to $ 125 delivered in the continental USA

[gsusmaniac]

do you still have this?

[DORIGTT]

Yes I do still have it.

[gsusmaniac]

Just out of curisity, do I need a special pressure plate to go with it?

[DORIGTT]

No. It is from Kennedy Engineering for the T-4 to T-1 gearbox conversion.

[gsusmaniac]

Sweet, alright, I just bought an engine... so give me a week or two to get the money and I would love to take it off your hands.

ERIK

[jmitch17]

I bought a type 4 2.0L for my 65 notch.... Will I need one of these to complete the conversion??? I am just getting started... any help would be good. Joel

[ernyb]

Do you still have the Kenendy flywheel? Eric.

[DORIGTT]

Yup. It's still hanging around

[ernyb]

Thanks for the quick reply. How much? I would pick up since I am local. Eric.

[DORIGTT]

I apologize folks.

I just checked my invoice from Kennedy Engineering and the flywheel is for a T4 - Porsche 915!

ooops!

[Type4Unleashed]

I'll take it, pm me your # so we can set up payment.

Thanks

[DORIGTT]

Just to make sure we're clear Richard. It's a Kennedy flywheel for using a Porsche 915 transmission with a Type 4 engine.

[Sandeep]

If Richard does not take it, I will.

Sandeep