|
#2
|
|||
|
|||
carbs
hi
what carbs are you running on your car...and tell me abit more about your motor..love your seats |
#3
|
|||
|
|||
Quote:
Here are my engine specs... 1775c CR 7.6:1 Case - Volkswagen, AS21 (German), dual relief, 8mm studs, case saver inserts, deep #3 studs, tapped for full flow oil system, .020” over line-bore, fresh thrust cut and custom bearing 69mm welded counterweights, 8-dowelled Stock rebuilt rods 90.5mm Mahles Sig Erson 200 (.441” lift and 280˚ duration at cam) Gene Berg semi-hemi with mild port job Valves - 35.5mm intake (Brazilian), 32mm exhaust (German) Solid rocker shafts with stock 1.1:1 rockers Gene Berg single springs and retainers. Chromo pushrods. Stock resurfaced lifters. Mazda swivel feet adjusters. Dual Webber 44mm IDF's with K&N air filters Gene Berg fan mount linkage 1-1/2” merged with custom extended 1/3 pipes to allow thermostat and stock tin - or street header and heaterboxes Shadek oil pump (26mm gears), Gene Berg full flow case fitting, remote filter, Gene Berg 1.5 quart deep sump, steel braid teflon hose, Castrol GTX 20w-50 stock 1977 fuel injection fanshroud with additional nut welded in flush for use with Gene Berg linkage, late model fan 1500lb Scat clutch with stock disc Stock flywheel lightened to 12-1/2lbs 8-dowelled Aluminum stock diameter pulley with degree ring Empi 75 Amp alternator Bosch blue coil mounted to firewall, 009 distributer, Bosch silicon plug wires Misc. - Clearanced stock valve covers for valvetrain |
#4
|
||||
|
||||
nice car nice name
i will be using twin 40 dcnf's on my 2 ltr type 4 (dare to be different..)
how did you get round the fuel surge and starve problem on corners or are they from gene berg??? if so can you send me a more detailed picture... my mate has a set on his beach buggy (1641 type 1) and they run great but splutter a little in tight bends (cheaper than idf's to buy in the uk as are off a late MG and everyone is scared about there cornering problem ) thanks kafer.chris (UK) |
#5
|
|||
|
|||
I ran nearly stock 40DCNF's and stock 42DCNF's with no problems in the turns...I now have GBE 42 specials, but have yet to use them.
I cannot remember what trick parts were in the otherwise stockers...I'll have to pick my Dad's brain. |
#6
|
||||
|
||||
if you could it would be of much help too me .
thanks chris from chris p.s that's one cool users name by the way!!!! |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|