shock tower clearancing for 944 spring plates

[LOAF]

Zen, I am most curious too..

I am doing 78 vert, and have to wait for the weather to heat up a little.. but once it does I am sending my torsion bar housing to get dismantled by a local porshe guy, so that I a can transplant.. I figure I can do the ones on the car with the right tools..

When I do the swap I know I will encounter the same.. BTW are you using early or late rear trailing arms.. on yours. I can't remember but I have been following you build up..
Sincerely
Alex

Originally Posted by Superman

You have to clearance about 2mm from the Beetle's chassis frame in the area behind the Porsche's eccentric bolt back. Unfortuately, the only way to do this is with the spring plates off the car.