fiber glass custom parts

[Martice]

Hello,
This are the mounting instructions for super beetles- 1302 and 1303.
(I will try to supply all the mounting parts and mounting instructions for with each spoiler)


Mounting parts:

2 bolts M 5 X 20 mm with permanently attached washer
2 washers 5.3mm
2 lock washers 5.3mm
2 nuts M 5
4 rubber discs 5 X 20 mm, 5 mm thick.


Mounting:

Spoiler fits vehicles produced up to 7/74 and after 8/74.Use outer holes for vehicles produced up to 7/74- inner holes for vehicles produced after 8/74.Production tolerances may make it necessary to file out the holes.

1.Attach spoiler using bumper bolts. Spoiler is positioned in the bumper, between the bumper and mounts on 1303 produced after 8/74.
2.Drill through holes present in spoiler into the lower edge of the fenders using a 5.5mm dia. bit. Align if required.
3.Attach spoiler to fender with bolts-washers and lock washers, and nuts from rear. Position rubber discs between fender and spoiler.Use 1 or 2 discs as required for adaptation.

I hope it helps!