#1
|
|||
|
|||
914 dash panel, or just a good source in Dallas?
Hey, Joe, I'm looking to replace the distorted, shrunken vinyl on my 914 dash (the flat part) with a hunk or so of CF.
As it is like a 3"x4 ft flat steel piece in several small sections, I figure I could do it myself and just glue it on to the old steel bits... This is purely cosmetic... (Actually, CF knee and dash covers might be quite popular, but I know you're maxed out with the new job and such) ciao |
#2
|
|||
|
|||
I've been wanting to do that to my 14 too.
|
#3
|
||||
|
||||
I can make you a thin (.030) panel or panels with an adhesive backing, that you can cut and fit yourself. Just let me what sizes and I'll let you know the cost
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Thread Tools | |
Display Modes | |
|
|