GermanLook Forums  

Go Back   GermanLook Forums > Technical Section > Engines

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #3  
Old August 9th 2003, 15:58
petevw's Avatar
petevw petevw is offline
Moderator
 
Join Date: Jul 2002
Location: toronto, ontario, canada
Posts: 1,348
effvee,

i respect your thoughts and opinions, but i totally disagree. i have a BIG 2332 and i love it. i only get oil squirting out if the dipstick, when im on the highway cruising at 4000-5000rpm. sure it makes a mess, but i spray on the engine desgreaser, hose it down, and its new again. my 94's are good haven't had a problem with them. 94's are cima barrels, and wiseco pistons. i have all my oil plumbed with 3/4 parker hose or pipe. my breathers are 1/2, which i will change to 3/4 when i take the valve covers off to adjust valves. i bought my case from fisher buggies, it was clearanced for a 82mm crank, and i dropped my 84 crank in, and had to clearance very little. the eagle rods (chevy journal), didn't require a lot room, so additional clearancing was minimal. motor runs cold, doesn't really see any heat unless i beat on it, or i'm cruising at a good rate on the highway.
sorry about your luck.

pete
__________________
'72 super
'65 bus
'52 split
Reply With Quote
 


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 07:51.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
© www.GermanLook.net 2002-2017. All Rights Reserved