|
i used the camber+ kit with the 944/maxx setup and it helped some but did not move the control arm out far enough to remove the positive camber...so...i used the HR TripleC to move the top of the spindle towards the struts to remove more positive camber...have not measured it..yet but its closer than it was..
if your not far off from where you need to be...i would use the hr ...it is also easier/quicker to install and adjust than the camber+
also make sure to use part# tc212 instead of part# tc112 as on the hrsrping website....the website is incorrect...i learned the hard way and had to return/reorder :shrug:
|
December 22nd 2004, 18:11
Threaded Mode