Wishbone suspension bolt on kit

[Alex]

Jason,

Your frame design has to be a two piece then that needs to be bolted together. There is not very much room in the wheel well cut out and between the frame head and body. The other thing is that the wishbones are to far back....too close to the frame head which could lead into the wishbone touching the lower tray under the frame head that extends out at the edge. I am not too sure were the spindle sits in height.....I have to check on my pan.
The best design I have seen so far is the one that Martin "dobergoose" has on his pan although the frame head is gone. I talked to Mark and he will make some changes on his design. If you have no frame work in front of the frame head you can not bolt on the body to the front unless you make some brackets for it.
There are a couple of pics in the Suspension gallery of Martin's setup and a wishbone that Remmele made for his blue racer.
If you want post your design as an attachment.

Alex