Which do you think makes the car look more GL?

[rip]

okay so here's my calcs

with the struts allowing only 6" of bcksp (~152.4mm)
then assuming your billet hub increase width by .55" (~14mm)

okay so lets look at your wheels 8.5" (~215.9mm)
ET is 52mm
center is 108.0
assuming a 12.7mm bead lip
your bcksp is 172.7mm
your frntsp is 68.7mm

Now the stock ones 4" (~101.6mm)
ET is 40mm
center is 50.8
assuming a 12.7mm bead lip
stock bcksp is 103.5mm
stock frntsp is 23.5mm

with the brakes your bcksp will be 172.7mm-14mm=158.7mm
now 158.7mm is about 6mm more than the allowed 6" of bcksp so see if Lanner can make those hubs a bit wider or use spacer

Now for the front 68.7mm+14mm=82.7mm and comparing that to the stock front space of 23.5 your over by 82.7-23.5=59.2mm which is a little bit more than 2", by about 8.3mm.

So if you want a slightly tucked look 4.4mm in compared to stock or a little bit pushed out look of 8.3mm compared to stock, it up to you, but this will all change with the brake's spacing.

good luck