|
Yes, I have seen Hugo's and have emailed him a couple of times. Real nice guy. I had not seen his car at the time I designed and mocked up my chassis. I will admit that after I saw his set up I made a change to the rear of mine by adding the upper frame rails for the upper control arm attachment piont. The front of my chassis will be significantly different. Another major difference is that my chassis has a bigger perimeter rail that is recesed into the heater channel area. My heater channels were shot so rather than replace them I cut out the inner section and bottom plate and replaced the lost strength with the new perimeter rail.
Last edited by PJL54Oval; November 21st 2005 at 18:52.
|
November 18th 2005, 09:56
Threaded Mode