|
|
|
|
#2
January 8th 2006, 13:42
|
||||
|
||||
|
Naahh. not going to sell kits. only the instruments wil cost you 300$ from summit. and the panel is cnc milled out from a 15mm thick block of 7075-T6 aluminium. (Harder than steel). so if i should mass produce this, it would be so expensive than no one would buy it...
But i could give you the CNC drawings if i get royalties when someone starts to produce it. Vin
__________________
Check out my project pic`s! http://www.v-dubs.no/haraune 
|
|
#3
January 10th 2006, 22:45
|
||||
|
||||
|
I think the hood scoop on the UniRoyal racers is pretty menacing looking.
I like the styling and aggressive look of the UniRoyal cars...if I could get mine to look like that I would. Perhaps some NACA ducts under scoop to feed fresh air to carbs or even a oil cooler mounted in the rear somewhere. Ive seen people mount an oil cooler w/ fan under the parcel tray near the tranny so I could see how a scoop with ducts could help force more air over the cooler. Probably more air than the fan alone could draw. To each his own...
|
 |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
