|
|
#12
May 15th 2006, 12:08
|
||||
|
||||
|
FWIW, CB says they have never seen a bad spindle cause this issue and suggested to check the control arm for bend, the ball joint orientation within the control arm (notch lined up), or swap the eccentric. It doesn't take much...
Even though my beam is "new" it doesn't mean the arms are. They could be remanufactured and not be straight. 
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode