GermanLook Forums  

Go Back   GermanLook Forums > General > Project Builds

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #10  
Old August 25th 2006, 15:40
Humble's Avatar
Humble Humble is offline
Registered User
 
Join Date: Jan 2003
Location: Boulder Creek, CA
Posts: 758
A little more progress on the bug these past few nights, some good some bad.
Got a few more parts in, koyo alu. radiator for a 93-97 rx7 turbo, 944 to beetle e-brake adapter swans for vdub engineering (very cool guys), wilwood clutch slave cylinder, and intercooler water pump from a 2002 ford lightning.

Test fitted the 1" spacers on the front and finally mounted the calipers (they don't fit without the spacers), and I tried the 2 sizes of fuchs that I have to see if they both clear inside and out.

6jx16 et36





I tried the 7jx16 et23 on the other side, I think it would be kinda sketchy but I can dial in up to 6 degrees of negative camber if needed.





Another project that didn't go so well is running my fuel lines. I ran fish tape down through the heater channel from the front and taped my fuel lines to it then tried pulling it back through. It got jammed right at the bottom corner of the door where it turns up and goes into the trunk under the fuel filler. I really want to use that route but I think it might neck down to small for the -8 and -6 AN lines.
Reply With Quote
 


Currently Active Users Viewing This Thread: 3 (0 members and 3 guests)
 
Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 17:26.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
© www.GermanLook.net 2002-2017. All Rights Reserved