|
|
|
|
#1
May 21st 2007, 10:07
|
||||
|
||||
|
Pete,
When I installed my motor last weekend, I had the same problem with the last 3-4mm. It would not seat so I took the motor back out and loosened the clutch cable all the way. That worked for me. Have you tried it with the clutch cable totally disengaged ? Sandeep 
|
|
#2
May 21st 2007, 13:36
|
||||
|
||||
|
Quote:
__________________
'72 super '65 bus '52 split
|
|
#3
May 22nd 2007, 20:01
|
||||
|
||||
|
Pulled it out right after i posted yesterday. Went outside, and fired it up and listened with a smile on my face, then i got
 shut it down and ripped her out.  Worked on it today and this is what i found (posted in the trans section): http://www.germanlook.com/Forums/sho...ed=1#post59248
__________________
'72 super '65 bus '52 split
|
|
#4
July 5th 2007, 23:42
|
||||
|
||||
|
Motor runs and have driven around a bit close to home. Carbs are running rich, so it has what i think may be a flatspot. I don't know, seems like carb lag. Can't find the port to plug the laptop into these Dells.
I'm gonna try and bump the timing tomorrow. Still have to unbolt the towbar plate. It has bottomed out a few times, scaring the crap out of the pedestrians.  Rear carpet, rear seat, gen idiot light, a quick detail, and she should be ready to cruise/show this weekend. 
__________________
'72 super '65 bus '52 split
|
|
#5
July 6th 2007, 23:30
|
||||
|
||||
|
Nice to hear you are so close to driving an air-cooled again. Hope you make the cruise out to Kitchener with no problems. :agree:
|
 |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
