|
|
#20
February 2nd 2012, 00:30
|
|||
|
|||
|
I don't think it's necessary and I don't recommend it. And if you go with the Tool Steel Type 1 lifters, just leave them alone. They are not broke, so don't fix them.
And I have seen a couple sets of Type 1 lifters that went bad and it looked like it was because of the oiling hole ? But if you have to have it done, any EDM shop can do it. http://www.qualityedm.com/ http://www.manta.com/cmap/mryctbd/reliable-e-d-m
__________________
Richard Last edited by Type4Unleashed; February 2nd 2012 at 11:44. 
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode