My other 1303 GL

[Wally]

Originally Posted by Steve C

Looks like I have to use a 1/4 inch steel flywheel scatter shield. I tried searching and of course your build thread came up. I started looking through the 104 pages on your build and gave up.

These I still had on my phone:




Basically my buddy bend some 6mm thick and 10cm wide plate round the G50, which I welded to my old tranny cradle. Its heavy, but as you said, mandatory to run at most drag race tracks under 11.9 sec iirc.
For circuit use I can unbold the top section, which then saves some weight.

[Steve C]

Thanks Wally, really useful photos and information.

I'm using a Subarugears mount and factory Subaru engine mounts. I could weld the lower part to to the Subargears mount