#1
|
|||
|
|||
AN engine inparts for sale.
AN T4 engine, 1800, 85 hp DIN, from a 412 S.
Engine is dismanteled, and will be sold complete or in parts. Engine is an original Volkswagen rebuild. Two very good heads, 41*34. Flywheel with support bearing for use in T1. Two stock T4 heat exchangers with 4-1 header and oval quiet silencer. One bearing frozen on crank. Rusty cylinders, but can be bored for 96mm's. Will be sold to highest bidder, or at my discretion. If any interest, please reply to the address below removing the obvious. BergRace@Chello.twat.no
__________________
P.J.Berg. |
#2
|
|||
|
|||
Current bid's:
Two heads: 200,- US $. Heater boxes: 75,- US $. Flywheel: 70,- US $.
__________________
P.J.Berg. |
#3
|
|||
|
|||
Flywheel and clutch is sold.
__________________
P.J.Berg. |
#4
|
||||
|
||||
hello.
plastic air intake boot ? o well thought not worth a try!!!
__________________
neil verdon 66 sqr on irs. |
#5
|
|||
|
|||
Sorry no plastic boot.
Following is sold: Clutch Flywheel Exhaust (inkl. heat exchangers) Heads Carbs Intakes Case. Only things left: Tinware Generator Block heater 240V for the mysterious second drain plate! Stock cylinders(needs boring). Stock domed pistons(Can be saved if in a tight pinch, will need rings) Air cleaner setup for dual carbs. Cooling fan with pulley Crank 66mm (will need turning) Rods.
__________________
P.J.Berg. Last edited by BergRace; December 27th 2002 at 05:55. |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|