|
|
#1
December 14th 2003, 13:42
|
||||
|
||||
|
944 tach wires
Hi,
I have the 944 tach in the picture and I don't figure out how to wire it. The problem is that it has 6 inputs and my last tach had only 3 (+/- and ignition coil) Any suggestions would be nice. Martin 
|
|
#2
December 14th 2003, 13:45
|
||||
|
||||
|
hear is he front.
Oh, and does anyone know how to demount the tach? I remove the 4 screws on the back, the inside of the tach is loos but it seems like the tach its sealed... M.
|
|
#3
December 26th 2003, 11:01
|
|||
|
|||
|
Hi,
I’ve got the same gauges in my GL, the outer ring (Bezel) is “just” snapped on the pot, you’ll have to use a screwdriver to open it, they’ve just bent it over the pot! Be very careful ‘cause I’ve broken a couple of them and it’s very hard to find new one’s (and expensive to! 25.78$ a piece!!!) Serge aka Coxbow
|
|
#4
December 27th 2003, 07:35
|
||||
|
||||
|
Terminal (4) is 0v, (5) is +12v and (6) is to the L.T. side of the coil.
The terminals are labelled on the PCB only. I've never seen that yellow print  Matt
__________________
'79 Karmann, Nrburgring or bust... Last edited by MattKab; December 27th 2003 at 07:39.
|
 |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
