|
#1
|
|||
|
|||
I´m sure it won´t take long before become that nutty aslo
|
#2
|
|||
|
|||
You´re right about turbos loving high lift,I might trade it in for my original choice the webcam 163.I haven´t really decided yet.I like the 86a because it´s a "quiet" cam and easy on the valve train and still pull to 7K.As you know choosing the right cam is always a challenge.What doesn´t make it any easier is following your experiences and seeing and driving with Armin´s 2 liter turbo with a low (11 mm) cam and the performance that his engine has.It´s actually not that spectacular riding in Armin´s turbo and you think at first it´s kind of a pooch,then you glance over at the speedo and you´re doing 260K/mh.His car doesn´t have the snap or agressivenesse that we see with the type 1s i.e. 2276 or so.But it´s just incredibly fast.It´s a ticket magnet...
|
#3
|
||||
|
||||
Well, your the builder, you must choose eventually
|
#4
|
|||
|
|||
A very small update: The CU heads are back from glasbead blasting.To my surprise,they are in much better shape than I thought! Today they are getting shipped off for porting,seats,valves etc.
|
#5
|
|||
|
|||
Another small update.The case work is finished.The mains had to spindled out to 0.50mm.Now I will clean the case up a little better and then install the Raceware headstuds.
|
#6
|
||||
|
||||
Good progress!
What are those weird looking copper-coloured thingys sticking out from under the bores? |
#7
|
|||
|
|||
Quote:
Oil squirters to cool the pistons.Simple but effective |
#8
|
||||
|
||||
Thought so, but how are those fixated? Mine sit much higer up and into the bearing saddle.
|
#9
|
|||
|
|||
The saddle is tapped and the squirters are screwed in.The squirters are the tips from a wire welder.I´ve seen others use grease nipples/fittings aswell.
|
#10
|
||||
|
||||
guys, what size do you think is best for the hole in the squirters? And do you have a closer look picture of them?
__________________
www.vw1303s.com |
#11
|
|||
|
|||
There are different options.My case uses the tips from a wire welder with an M5 thread.Location and angle are the key to make it work properly,though.
|
#12
|
||||
|
||||
Xellex,
I use the squirters from a 911 turbo. Those also have a check valve inside so your oil pressure doesn't drop at (hot) idle. They open at 2 bar or there about Mark, Did Remmele install these for you? Tnx, Walter |
#13
|
|||
|
|||
Quote:
|
#14
|
|||
|
|||
Another small update - my billet single stage dry sump pump from Thorsten Pieper came in.It has a 3 piece housing with 32mm gears.
|
#15
|
||||
|
||||
nice! Can these be ordered online? I only found vague information about thorsten pieper on the web.
__________________
www.vw1303s.com |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|