![]() |
#1
|
|||
|
|||
My Project....Superbeetle Conv. 2.4l with EFI - Megasquirt
Hi,
don´t know where my oldeer Thread is, so i will show you some Information about my project. First my Convertible ![]() Full Docu about the resto at http://kcc-niederrhein.de/index.php?...egory&catid=19 Last Winter build a Typ4, 2.4l ..hooked up a efi ![]() best regards Markus
__________________
http://www.carbonworks.de Interior Goodies in 100% cfk for your Superbeetle http://www.kcc-niederrhein.de Käfer Cabrio Club Niederrhein Germany Last edited by maniac; April 19th 2011 at 10:37. |
#2
|
|||
|
|||
Heres a pic from the dashboard
__________________
http://www.carbonworks.de Interior Goodies in 100% cfk for your Superbeetle http://www.kcc-niederrhein.de Käfer Cabrio Club Niederrhein Germany |
#3
|
||||
|
||||
Very nice work. Love the dash.
__________________
NO_H2O 72 1302 Smack Black GL 73 Bus (2L CIS Powered) 66 Beetle, 73 Standard Beetle 72 Pinzgauer 710M Volksport Kafer Gruppe |
#4
|
|||
|
|||
will make same better pics, cause this pic is from the last year and a little bit dirty
![]()
__________________
http://www.carbonworks.de Interior Goodies in 100% cfk for your Superbeetle http://www.kcc-niederrhein.de Käfer Cabrio Club Niederrhein Germany |
#5
|
||||
|
||||
great looking car! Love the dashboard, it is similar to what I did a few weeks ago
![]()
__________________
www.vw1303s.com |
#6
|
||||
|
||||
Great job, I'm going to go through all of your gallery now!
Rich
__________________
http://www.ricola.co.uk |
#7
|
||||
|
||||
Love the wheels, what are those?
Jason
__________________
If I could just get paid for my sleepless nights.... 1960 VW Bug UBRDUB Walkaround 1st Drag Run Dyno Run Oval Ragster-'57 Rag/'04 Boxster S |
#8
|
|||
|
|||
Wheels are Tomason, located in Germany Essen. Its a local Enterprise
Dimensions are 8.5x18 ET35 in front and ET15 an the rears
__________________
http://www.carbonworks.de Interior Goodies in 100% cfk for your Superbeetle http://www.kcc-niederrhein.de Käfer Cabrio Club Niederrhein Germany |
#9
|
||||
|
||||
well done
![]() |
#10
|
|||
|
|||
What the hell
![]() After first Startup...ecu runs fine, but no oilpressure Only 0,5-1bar pressure at 2000 rpm....that sucks
__________________
http://www.carbonworks.de Interior Goodies in 100% cfk for your Superbeetle http://www.kcc-niederrhein.de Käfer Cabrio Club Niederrhein Germany |
#11
|
|||
|
|||
Hi Markus! You guys should see the car in person,it´s very well done! Did you bleed the oil lines and oil cooler properly Markus? Also check your oil pressure gauge or swap it with a gauge that you know works.
Another possible reason could be that your pick up tube inside the case isn´t properly fit or too high above the sump.The pick up tube may not be able to suck enough oil if it is not properly installed.That would be a problem because you may have to open the case again.I hope that´s not the reason and it is something simple.. Last edited by 70Turbobug; June 15th 2010 at 05:48. |
#12
|
|||
|
|||
I love this dash, can we get more pictures? You did this with 914 gauges correct? I've seen a few custom dashes like this on here and would love to see an in-depth "How to/DIY" from start to finished product cause I would like to do the same for my project Mike |
#13
|
|||
|
|||
we have opened the case again and hope to find the problem
one of the plugs blocks the oilchannel (only 50% of the diameter are open) @Turbo we have checked all things befor open the case again.. ![]() Have to drill out the plug and hope that the oilpressure will ok now. Another little Proble was the Mahle bearings... seems they are not fitting like K&S bearings, 6/100mm smaller in diameter than the K&S bearing...that sucks Change also the mahle bearings to kolbenschmidt
__________________
http://www.carbonworks.de Interior Goodies in 100% cfk for your Superbeetle http://www.kcc-niederrhein.de Käfer Cabrio Club Niederrhein Germany |
#14
|
|||
|
|||
Engine is back in car and oilpresure ist fine...
cold engine= over 5bar ![]() Next friday we will programing the EFI. Car runs up fine already, only need to program some finetuning bst regards markus
__________________
http://www.carbonworks.de Interior Goodies in 100% cfk for your Superbeetle http://www.kcc-niederrhein.de Käfer Cabrio Club Niederrhein Germany |
#15
|
|||
|
|||
**** happens...
at 3500 or lest at 5000 rpm, engine ecu gets offline... no idea why....grrrr think theres an electric bug in the system...alternator damaged ![]() Sometimes the vr is not registring the tooth... for the video-junkies. Video "first run" http://www.youtube.com/watch?v=gcRMUnd_A70
__________________
http://www.carbonworks.de Interior Goodies in 100% cfk for your Superbeetle http://www.kcc-niederrhein.de Käfer Cabrio Club Niederrhein Germany |
![]() |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|