|
|
#1
January 23rd 2003, 16:04
|
||||
|
||||
|
993 RS calipers on 951 alloy arms
I have '86 951 alloy arms and the narrow hubs. The 993 RS rear rotor fits over this and its centerline is where the stock 951 centerline used to be. The e-brake parts should work just fine once the cables are modified with the Kersher parts. I have 993 RS calipers, which are the same as Turbo calipers except they have smaller piston bores. What difficulties can I expect when I am going to assemble these parts? I think the calipers will not bolt straight up to the mounting tabs/ears on the trailing arms. Weld, re-drill and tap the holes?
Brian Last edited by verbeekb; January 24th 2003 at 02:45. 
|
|
#2
January 24th 2003, 02:23
|
||||
|
||||
|
Hello Brian!
The calipers are a bolt-on the only modification it needs to be done is to have narrow the inside of the caliper bolt holes. Take some measurements I THINK they need +/- 3-6mm but not remember exactly how much... Good luck
__________________
Jim Andritsakos 74 1303 GL (project) 75 181 ex bundeswehr / 85 T3 Panel 86 T3 Syncro ambulance / 87 T3 Syncro doubledoor 16 89 T3 Syncro panel
|
|
#3
January 24th 2003, 02:37
|
||||
|
||||
|
Thanks Jim!
I was worried that the rotor would be too big in diameter and the caliper would have to be moved further out. I understand I will have to center the caliper over the disk. Thanks again, Brian Last edited by verbeekb; January 24th 2003 at 02:43.
|
 |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
