#1
|
||||
|
||||
Painting 944 rear hubs
I am sandblasting and spraying all my 944 rear suspension parts prior to fitting - is there any issue with me doing this to the early rear hubs? I will protect the threads with tape, but didn't know if there was an issue with the surface where the disc attaches to the hub.
On a related note - any one know what thread and size the screws to hold the disc to the hub are? Neither of my hubs had the screws - I know this is no issue as the wheel and wheel nuts hold them on but would like to have all parts present. Thanks Paul |
#2
|
||||
|
||||
it will be ok as long as you don't lay on an inch of paint
I'm getting all my parts powdercoated, & I'm just going to make sure, after 50 miles of driving to recheck all the torque settings once all the mating surfaces have settled together
__________________
66 type1 cabrio, 2276 DTA FI, Brembos, Servo, IRS, Berg 5 Quaife etc project in progress |
#3
|
|||
|
|||
If you use spray paint get VHT as it's the best for this type of application.
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|