T-1 clutch+915?

[Turbo Haraune2]

This winter's project is to install a 915trans into the subaru powered 1302GT.
Since i had the adapter for the original trans and a brand new kep stg3 clutch, i was wondering if the splines of the clutch disc wil fit the 915 input?

If not is it enough to only change the 200mm disc to a custom unit that fit to the 915?

[tomac]

This one fits to the 915 gearbox. Originally for the 164 Alfa, Lancia etc. 228mm 20 splines. Original Sachs Number. Good luck to get one.

http://shop.snowperformance.de/sachs...799/index.html

[1303R]

Originally Posted by tomac

This one fits to the 915 gearbox. Originally for the 164 Alfa, Lancia etc. 228mm 20 splines. Original Sachs Number. Good luck to get one.

http://shop.snowperformance.de/sachs...799/index.html

is it just the friction disc that fits or does the clutch pressure plate fit a 228mm wasserboxer flywheel?

[tomac]

I use that friction disc with a 228mm stage 1 bus pressure plate from KEP!

[ricola]

if the 915 is the same as the G50, I heard an early style 928 disc should do the job (200mm)

[Wally]

Originally Posted by ricola

if the 915 is the same as the G50, I heard an early style 928 disc should do the job (200mm)

No, different input/spline shaft...

[Wally]

Originally Posted by tomac

This one fits to the 915 gearbox. Originally for the 164 Alfa, Lancia etc. 228mm 20 splines. Original Sachs Number. Good luck to get one.

http://shop.snowperformance.de/sachs...799/index.html

Cool!
But that is a very high tech sport disk with organic clutch material...and therefore 229 euros!
Would a stock alfa 164 disk have the same measurements?

[tomac]

Yes Wally, the 164 228mm 20 spline disc fit to our 915 tranny. You can look up the number in the sachs catalogue. I use the one on the picture.

[Wally]

Tom,
The picture you showed is quite a different one than in the catalog. Yours has springs. The one in the link looks way different ??
Well, I'll visit my local parts house and check it out; Thanks again!

[tomac]

Wally, this is the order number out of the zf-trading catalog. The original 915 spline size comes in @ 20,1x22,3-20N. Did lot's of research in the catalog to find this. Got one on ebay for 20€ and found out that it really fits firmly on the 915 shaft. Believe this will make life easier for those crazy enough to force this gearbox into a beetles arse.

SACHS 1862 256 131 Kupplungsscheibe

* ab Fahrgestellnummer : 6156485
* Kenngröße: 228TPB
* Durchmesser [mm]: 228
* Nabenprofil: 20,1x23,1-20N
* Zähnezahl: 20