#29
|
|||
|
|||
Gents, we need to pool some info.
Also how thick do our adapter plates need realistically to be? And how are we sealing to the bell housing face - can we go as far as clearancing this a bit and using a different seal or indeed the rear of the slave cylinder. Ive been chatting to a guy at Sachs about one. Its a VAG 1.9TDi part that will require some mods, but it is ~40mm pressed total height, ~33mm to the mounting face ~60mm extended total, ~53mm to mounting face single pipe to feed/bleed 60mm OD bearing face PCD of mountings ~85mm I have some nice spec/pictures too which is very useful. Luis, is it possible to get those sort of specs from yours? |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|