#1
|
||||
|
||||
Torsion bar measurment
Hi
Its a long story, fitting G50, but the short story is I’m moving my inner torsion bar location points further out in the tubes so I can fit early bug length torsion bars in. As I’m using stock 944 arms and spring plates I need to have the torsion bars protrude the correct amount, this measurement would be the same as any IRS bug. What I need is the measurement from the face where the torsion bar rubber cover bolts up to the tip of the torsion bar. I measured this on my car and wrote it down and now I cant find it. Your help would be useful Steve
__________________
STI powered 1303 in the works. |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|