#1
|
||||
|
||||
Pictures of coolant line routing
Hello all,
I'd like to see some examples of coolant line routing from those running watercooled engines in their GL projects. |
#2
|
||||
|
||||
Hi
This is my old 1302, the main lines follow the heater channels bolts and are held by brackets attached to the heater channel bolts. Steve
__________________
STI powered 1303 in the works. |
#3
|
||||
|
||||
Note the hose clamp holding the tubing on the above 2 photos. I loved the simplicity of it. I just cut a small slot at the base of the pan with a Dremel cut off, then threaded the clamp through, around the tubing, then tightened it up after adding some rubber tubing behind it to prevent chafing. This was just a temp bracket... Jason
__________________
If I could just get paid for my sleepless nights.... 1960 VW Bug UBRDUB Walkaround 1st Drag Run Dyno Run Oval Ragster-'57 Rag/'04 Boxster S Last edited by volkdent; April 21st 2008 at 21:16. |
#4
|
||||
|
||||
My ghetto install:
Straigh pipes running under the car: Link the pipes to the motor: Flexhose linking the main pipes to the engine: Here you see that my header is still lower than the pipes. Haven't hit anything (yet): Side view: Radiator: Rob. |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Thread Tools | |
Display Modes | |
|
|