|
|
#1
May 17th 2014, 14:03
|
||||
|
||||
|
Master cylinder sizes
I am putting an OBP pedal setup in my car and wanted some recommendations on master sizes for front rear and Trans hydraulic actuation. I should know the answers but 10 years of building this thing has blurred many lines...
Thanks guys!
__________________
Meyers Manx Signature #85 , 79 Convert 
|
|
#3
May 18th 2014, 09:09
|
||||
|
||||
|
I know Tilton has a worksheet for their products. OBP may have one for theirs.
__________________
NO_H2O 72 1302 Smack Black GL 73 Bus (2L CIS Powered) 66 Beetle, 73 Standard Beetle 72 Pinzgauer 710M Volksport Kafer Gruppe
|
|
#4
May 18th 2014, 15:04
|
||||
|
||||
|
I'm using 0.625s for my 996 brakes which is the smallest available and I would go smaller if I could... I have 0.75 for the clutch but that is dependant on what size slave, clutch etc you are running...
__________________
http://www.ricola.co.uk
|
 |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
