|
|
#1
March 24th 2003, 13:29
|
|||
|
|||
|
oil pump dimensions
I have an oil pump that was supplied to me as a 29mm pump. The inlet hole does not match up to the case 100%, so I will be moving it. I would just like to know if there is someone out there who has an oil pump lying around that may be able to help me with a simple dimension.
I need the distance from the mounting flange to the end of the pump gear boss and from the flange to the end of the pump gear tooth. By mounting flange, I mean the part which the case bolts fit through, where it meets the case not where the pump cover goes on. I basically need to face cut the flange 1.5mm but need to ensure that the cam insert still fits properly and does not push on the cam. Thanx a lot guys Tony Z
__________________
1969 VW aka Suicyde www.geocities.com/suicyde_vw Tony__Z@hotmail.com Last edited by Tony Z; March 24th 2003 at 14:23. 
|
|
#2
March 24th 2003, 13:43
|
||||
|
||||
|
Tony
I am going to move this to the correct forum. We dont do technical stuff here in the club forum.
__________________
WinterJam 2010: Vdub, Surf, Skate & Musis Fest WinterJam 2010 'I drive way to fast to worry about cholesterol!' '67 Sunroof Notchback * '68 FI Squareback
|
 |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
