GermanLook Forums  

Go Back   GermanLook Forums > Technical Section > German Look Tuning

Reply
 
Thread Tools Display Modes
  #1  
Old July 12th 2003, 17:26
Rob's Avatar
Rob Rob is offline
Registered User
 
Join Date: Jan 2003
Location: Dundas, Ontario, Canada
Posts: 786
Removable apron

I decided to make one of those removable aprons.
I already new something was fishy because the PO bondo'd the hell
out off the apron where it meets the fenders.

Upon removing the bondo, it appears that the apron is welded in ?
The weird thing is that it has a copper color...
Take a look http://www.vanbran.com/apron.jpg
The hole you see is the bumper hole, so you should turn the pic 90 degrees.

Since I can't use the 'drill out the spot welds' method, I'm thinking about just
running my grinder just along the edge to cut it out.
The only thing I am affraid of is that I cut too far..

Any ideas/suggestions ?

Thanks,

Rob.
__________________
EJ25 powered 1970 Standard Beetle
Subaru EJ25 in 1970 Beetle Project
Reply With Quote
  #2  
Old July 12th 2003, 19:09
Superman
Guest
 
Posts: n/a
Take a saw/torch and cut it down the center, then pull each side outward as if "peeling" it away. Then you'll have to grind away the spot welds. The method you posted could work as well.
Reply With Quote
Reply


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 18:40.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2020, vBulletin Solutions Inc.
© www.GermanLook.net 2002-2017. All Rights Reserved