1.7 type IV head

[effvee]

Hi everyone, I am getting to a point where I can get the second spark plug hole installed. I un-did some of my last porting, due to having seen someone else porting which I felt was much better. These heads are from a 411, they were from the 1.7 engine. I think the exhaust is 39mm X 41 or 40mm. Have a look and make suggestion on any imporvements I can make before the plug addtion and coating and "O" grooves.
http://i86.photobucket.com/albums/k97/effvee/2011-06-17_18-28-58_429.jpg~original
http://i86.photobucket.com/albums/k97/effvee/My%201302%20Affair/DSC00002_edited.jpg~original
http://i86.photobucket.com/albums/k97/effvee/2011-06-17_18-29-05_997.jpg~original
http://i86.photobucket.com/albums/k97/effvee/My%201302%20Affair/DSC00025.jpg~original
http://i86.photobucket.com/albums/k97/effvee/My%201302%20Affair/DSC00013_edited.jpg~original
This is the flange, the exhuast pipe will be welded to it
http://i86.photobucket.com/albums/k97/effvee/My%201302%20Affair/DSC00027.jpg~original
I will need to have the seats re-ground.
Hi, am havig my machinst mill me a "O" ring groove into the head and cylinders, man I need to get this engine running.
http://i86.photobucket.com/albums/k97/effvee/082411181008.jpg~original

[effvee]

Hi everyone, I had European Motorworks add a second spark plug to my 1.7 and 2.0 heads.
http://i86.photobucket.com/albums/k97/effvee/2011-12-17_12-12-35_641.jpg~original
http://i86.photobucket.com/albums/k97/effvee/2011-12-17_12-12-49_996.jpg~original
http://i86.photobucket.com/albums/k97/effvee/2011-12-17_12-12-29_274.jpg~original
http://i86.photobucket.com/albums/k97/effvee/2011-12-17_12-12-22_632.jpg~original
Here are the 2.0 heads.
http://i86.photobucket.com/albums/k97/effvee/2011-12-17_12-10-01_769.jpg~original
http://i86.photobucket.com/albums/k97/effvee/2011-12-17_12-09-54_376.jpg~original
http://i86.photobucket.com/albums/k97/effvee/2011-12-17_12-10-58_780.jpg~original
Jorge at EMW said that the second spark plug should be angled toward the exhaust valve, also there are 10mm. I will have the heads cryoed and re-coated.