|
|
#1
March 12th 2005, 22:27
|
||||
|
||||
|
Fiberglass frontend/missalined? how??
Hey guys
Well here we go again... I got all my NEW frontend parts on- ( 2" Narrowbeam/Tie rods,Stablizer,Shocks,Streering box,Trailing Arms) But now my Fiberglass front is off set.. it fits fine on the drivers side (right on the lip/under Windsheld) 1.25" off the tire Passanger side: is 2" off the tire & like 3" or so tweeked out by the running board.. anyone mess with this stuff before? Thanks Troy
__________________
SOLD!! 65 Bug 1835cc,Duel Dell 34's,BMD Serp Belt, A1 Perf. Sidewinder,CompeUfire Pointless Ign 95A Alt,CSP Valve Covers,Randar Diego 16's Soon [URL=http://www.cardomain.com/id/troy_audio] 
|
|
#2
March 13th 2005, 20:20
|
|||
|
|||
|
Did you pre-fit it before? If the FG frontend sat for a while, especially if it was in the sun or on a un-level surface, it's possible that it warped some.
__________________
Kafer_Mike Build 'em fast...or let 'em sit.
|
|
#3
March 14th 2005, 05:07
|
||||
|
||||
|
Damb
it was sitting for a few weeks.. socal had a bit of rain hot/cold changes... guess its time for $$$ NewOne $$$...eh..the pains going tobe hard to match..  This CreativeCarCraft is About $980 I was thinking a set of Bearclawl's to hold it down .. 
__________________
SOLD!! 65 Bug 1835cc,Duel Dell 34's,BMD Serp Belt, A1 Perf. Sidewinder,CompeUfire Pointless Ign 95A Alt,CSP Valve Covers,Randar Diego 16's Soon [URL=http://www.cardomain.com/id/troy_audio]
|
|
#4
March 14th 2005, 19:25
|
|||
|
|||
|
bearclaw latches right?! they would do a damn good job at holding the front end down....you could use them instead of dzus fasteners or what ever else your using...you would just have to think a way of mounting the release...
good luck!
__________________
There is no cure for our disease  '69 standard ( under the knife) '72 1302 GL ( under the knife and on hold) VolkSport Kfer Gruppe www.VolkSport.net
|
 |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
