Let There Be Brakes!!!

[Panelfantastic]

Educate me a little... bias bar means you have independent cylinder and resevoir for the front and rear and the bar limits pressure on one or the other?
Pressed end? Not sure about that either. They do have a specific flare (degree amount) on the ends but that's all I was aware of...
It would be really cool looking if you could use braided everywhere but of course that's a big no-no and a wee bit pricey.



Jeff-

[bean_8044]

you can buy a good flaring/bending tool for less than $100 from most places

[volkdent]

Originally Posted by Panelfantastic

Educate me a little... bias bar means you have independent cylinder and resevoir for the front and rear and the bar limits pressure on one or the other?

Jeff-

Yeah, there's a bar that runs between the front and rear master cylinders. On the bar is the sliding linkage. You can get a remote adjuster that is a knob that when twisted, will pull or push the linkage along the bar. It adjusts the pressure that each master cylinder sees.

Hopefully, if I select the right master cylinders, I won't need to get the proportioning valve, and just the balance bar will be enough to dial it in.

"you can buy a good flaring/bending tool for less than $100 from most places"

I've got a couple of benders already, but I don't have a flaring tool. I've also heard there are specific flares for specific situation ie the angles, so I'm going to have to do a little research before I can get it done.

Jason