Internal sway bar... stupid or possible?

ricola · #1 January 21st 2006, 05:45

Looking good Jeff, I bet you can't wait to get it back on the ground with the new rims!

Rich

Panelfantastic · #2 January 21st 2006, 07:35

Thanks Rich! Yes, I am veery anxious but it is gonna be a bit before it touches down again. I'm making changes to the cooling also and updating the master cylinder, adding hydrualic clutch, a lot to do before summer hits.

Jeff-

Panelfantastic · #3 February 17th 2006, 20:07

Finally got my bars back. They are about 34"s long, 1" round bar of 4340. I had to do my machining first, threaded the ends and drilled the holes for the grub screws. Sent them over to Ark. and had them cooked to about 40 Rockwell.

**volkdent** · #4 February 18th 2006, 01:46

Looking good Jeff. Nice floor too!

Jason

Panelfantastic · #5 February 18th 2006, 11:10

Thanks, and thanks!
The floor is just stained concrete with three coats of resin, a very long and painful story. In fact, I could probably write a book about building this new crib but you would get so frustrated by the first chapter that you would throw it away

.

Jeff-

Mikey · #6 February 19th 2006, 00:16

Those control arms look awesome. I can't wait to see more updates.

bug-er · #7 March 2nd 2006, 07:45

I didnt think it would be possible to weld to the control arms, I was under the impression that they were cast parts??
Adam

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)