Type 4?

**NO_H2O** · #1 February 15th 2006, 01:08

IF you are on a budget and you are sticking to a stock type 4 from a bus, you can do a "Joe Cali" coversion with a type 1 fan shroud (get the Joe Cali book from Jake at www.type4store.com .you can shorten a set of 411/412 heater boxes and use a bus (type 4) header/muffler or Jake's "econo" exhaust. You will however need a coversion flywheel/pressure plate.

Bebobug · #2 February 15th 2006, 14:20

Thanks, I'll get the book. BTW do you think it is possible for a grand?

**NO_H2O** · #3 February 15th 2006, 22:32

Yes :agree:

wrenchnride247 · #4 February 15th 2006, 23:03

I was going to suggest the "Joe Cali" conversion, but for most, its too much fabrication. Cutting and welding sheet metal can be a PITA sometimes unless you have a good welder and lots of time and patience. However, as NO_H2O said, it is cheaper than DTM kit, just not as easy.

Bebobug · #5 February 16th 2006, 00:26

Equipment & time is something I have a lot of but, my funding is something I have to watch. Thanks for the info. What is a good flywheel/clutch for this swap?

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)