|
|
|
|
#1
March 3rd 2006, 01:17
|
||||
|
||||
|
Looks like my suggestion wasn't too far off then! I don't think you'll want for any more, and the little ones are way more mobile.
Jason
__________________
If I could just get paid for my sleepless nights.... 1960 VW Bug UBRDUB Walkaround 1st Drag Run Dyno Run Oval Ragster-'57 Rag/'04 Boxster S 
|
|
#2
July 14th 2006, 18:13
|
|||
|
|||
|
Jeff,
Any news? Are the control arms already in place? How do they hold? I really like to know, because I have similar plans for my split. Luuk
|
|
#3
July 14th 2006, 19:19
|
||||
|
||||
|
Everythings in place, been waiting on a new master cylinder. Should have it on the road this weekend and will report back on how it all works.
Jeff-
__________________
No current VW projects 54 Chevy wagon LS2 AWD 56 Chevy Panel "Lost Cause" VKG Bastage child
|
|
#4
July 14th 2006, 22:38
|
||||
|
||||
|
I have not seen this thread before so I apologize for jumping in late. I like the idea of replacing the leaf springs in the tube with a solid bar to be used as a anti-sway bar. I am no expert on sway bars but is seems like two one inch bars will make it super stiff. You may decide that one bar is plenty. Usually stiff bars are 1 3/4 are used and they have diagonal arms that attach to the A arm on newer cars which provide a lot more leverage to twist the large bar. Have you done anything to stiffen the roll of the rear of the bus? It seems that a lot of anti-roll in the front will cause serious oversteer. Just my two cents, can't wait to hear how it turns out.
 Mike
|
|
#5
July 15th 2006, 07:42
|
||||
|
||||
|
http://www.hrpworld.com/index.cfm?fo...ction=category
Check out the link to the anti-roll bar rate pdf at the top of this page. I'm thinking threaded rod at the bottom, and one of these modified to work up top.
|
|
#6
July 15th 2006, 10:39
|
||||
|
||||
|
Dorigtt, where was this info when I was trying to figure out how to make these stupid things?!?
  VERY good link! I could easily use these on a future project. The splined ends offer lots of possibilities. Mike, I have one made up out of 1" bar stock but have not had it tempered yet or made any type of attaching brackets. YES, definately required to have them at BOTH ends, without a rear, this top-heavy bus would get super squirrelly at speed. Gonna look at the stuff Dorigtt posted and see if some of those pieces can make up something better for the rear. Jeff-
__________________
No current VW projects 54 Chevy wagon LS2 AWD 56 Chevy Panel "Lost Cause" VKG Bastage child
|
 |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Hybrid Mode
