how mad will this be in my bug (check the video)?

[adaptorman]

did my own drill and tapped discs

[adaptorman]

header tank and cooling system sorted
front end all welded up

shorternd my driveshaft

rear wing weled up

[adaptorman]

didnt want to cut it but had to be done (ok 4 a first attempt with angle grinder lol

[adaptorman]

and a video of it runing (hope you like it)couldnt rev it higher as theres old biddis nextdoor and wasnt water in the lump back then lol
http://video.tinypic.com/player.php?v=141nnk4

[ricola]

I'm sure you'll sort a way of getting cool air to the rad without cutting the bonnet like that, I guess it's OK to debug it...

So, when's the first drive?

Rich

[adaptorman]

Originally Posted by ricola

I'm sure you'll sort a way of getting cool air to the rad without cutting the bonnet like that, I guess it's OK to debug it...

So, when's the first drive?

Rich

it takes a lot more air to cool then ur std bug/scooby lump?and as it had the long bonnet not the later short type so couldnt use/fit a airscoop under the car,plus its very low lol,some work was done before i bought e.g lowerd,deseemed ?test drive a while yet matey but ill keep pictures etc coming and youll no when the time comes

[adaptorman]

Originally Posted by adaptorman

it takes a lot more air to cool then ur std bug/scooby lump?and as it had the long bonnet not the later short type so couldnt use/fit a airscoop under the car,plus its very low lol,some work was done before i bought e.g lowerd,deseemed ?test drive a while yet matey but ill keep pictures etc coming and youll no when the time comes

couple more here cooling system done


90percent of welding done,a new type assembly is next ,as the old aircool idea is no good?