|
|
|
|
#1
October 20th 2006, 23:40
|
||||
|
||||
|
Rich
How did you come up with your specs/ Did you compare to a remmelle setup or similar.. Going similiar route.. any info appreciated.. Alex
__________________
Alex Olaverri Sales Associate for Bug@5-Speed (US) Email: Bugat5speed@yahoo.com Tele: 973 204-5463 
|
|
#2
October 23rd 2006, 03:47
|
||||
|
||||
|
For the length those are actually the same as a stock rear damper, I don't run extremely low so that works for me. If you go shorter you also get reduced stroke.
The two standard damper body sizes are to either take 1.9" or 2.25" internal diameter springs, the smaller ones fit, the bigger ones don't so easy choice there! The main clearance problem is to the trailing arm, also the size of the cup that the lower mount fits into. For spring rates, there is a site that compares torsion bar diameters to coil-over spring rates which gives a good start for spring rates.. Hope that helps! Rich
__________________
http://www.ricola.co.uk
|
|
#3
October 23rd 2006, 08:06
|
||||
|
||||
|
Can you link me to the coil v. torsion chart?
|
|
#4
October 23rd 2006, 09:25
|
||||
|
||||
|
__________________
http://www.ricola.co.uk
|
 |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Hybrid Mode
