Pan what to paint with?

[wrenchnride247]

Originally Posted by AusSuper

how does powdercoating go with stone chips etc? ive wondered about that, once it chips cracks or anything nothings there to stop the exposed part rusting, you can't exactly fix powdercoated stuff as easy as things like POR etc, id love to know from people with experience aswell.

You are correct with trying to repair powder coating... (you just have to redo the whole part ). However, it takes alot to chip it (very flexible). When it does chip... you are correct in that there's nothing to stop rust. What I have done on parts prone to getting chipped is to "top coat" the color coat of powder with clear powder coat. This will add one more layer to keep from exposing bare metal. Get a piece of steel that has been "properly powder coated", and beat on it with a hammer . You will see it's very tuff stuff. POR 15 is a good choice, but in "side by side" test against Eastwood Co. "Encapsulator" the Eastwood stuff beat it. The test was done by a restoration magazine that was bias to both products.

[aircooled4life]

you should rhino line (or other truck bed liner) the whole pan. some of the brands are kinda expensive but there are so brands that you can paint on yourself or you can take it to a place that does it proffessionally and have them spray it.

it may make your car a little heaver but you will never have to worry about rust and it may help with sound deadining.

[bigguy]

you couild use masterseries as well. easier prep time then por 15.

[wrenchnride247]

Originally Posted by aircooled4life

you should rhino line (or other truck bed liner) the whole pan. some of the brands are kinda expensive but there are so brands that you can paint on yourself or you can take it to a place that does it proffessionally and have them spray it.

it may make your car a little heaver but you will never have to worry about rust and it may help with sound deadining.

Just make sure ALL signs of rust are gone before putting on bedliner material. It helps stop future rust, but does nothing for existing rust. Again, this is where the Eastwood encapusaltor comes in handy. It converts, and seals exsisting rust (like POR 15).

[ricola]

I use rustbullet, after using POR15 it is similar but much less fussy with prep..

[Racelook]

Epoxy.
Cheap layer of paint (to be sure to have an water-tight layer)
Bodyschutz
Top layer of good paint

[bt1211]

I did mine with rust bullet. Less prep work than por-15.

A good metal primer, then a couple of coats of enamel will be fine for a driver. Make sure you do your prep-work for any of these methods you choose.

Powder coating would be a waste unless this is some kind of high dollar custom, that was being paid for by the powder-coating company.

[NO_H2O]

We are doing an Oval for a customer and had the pan powdercoated grey and the beam and al other parts black. total was $700. I have some pix of the pan built up and it looks real nice.