|
|
|
|
#1
March 15th 2007, 08:25
|
||||
|
||||
|
Hey Wiebrand,
Where in Canada will you be ? If you are in the Toronto / Hamilton area you should drop by for a beer ! En dan kun je me ook ff helpen met mijn kever   To keep it on topic: is it possible the decklid warped because of the welding ? Rob. 
|
|
#2
March 15th 2007, 10:37
|
||||
|
||||
|
Quote:
__________________
B-Extreme B-Tuning..... Racebug is comming to get ya!!!
|
|
#3
March 15th 2007, 11:37
|
|||
|
|||
|
Part of the issue may be warping of the deckild as a result of all the welding. Are you going to install the rubber seal? If not, I'd split the difference on the center vs. edge gap using rubber spacers (doughnuts) on the pins to set the height...
__________________
Kafer_Mike Build 'em fast...or let 'em sit. Last edited by Kafer_Mike; March 15th 2007 at 13:13.
|
|
#4
March 20th 2007, 19:04
|
||||
|
||||
|
So far I could see today it's definatelly the rear panel that is more "round" then the original one. Will be banging it straight soon
 Today received the ordered hammer and dollies. I used it today a couple of times, and I must say quality is just so much better then the cheap ****.  Yesterday evening and 3/4 of today wordt on my car with an temperature against freezing. At first finished the scoop on the enginelid.   And also started with an upset of the dashboard. Wiebrand
__________________
B-Extreme B-Tuning..... Racebug is comming to get ya!!! Last edited by Racelook; March 21st 2007 at 09:31.
|
|
#5
March 20th 2007, 22:46
|
|||
|
|||
|
Much better... :agree: :agree:
__________________
Kafer_Mike Build 'em fast...or let 'em sit.
|
|
#6
March 23rd 2007, 10:49
|
||||
|
||||
|
looks like you are making some good progress, even if frustrating. i too am getting ready to tackle hood pins for the c/f decklid i have. my plan is to just fab some brackets that will mount to the stock hinge and latch locations and tie the hood pins in there. so i can flip back to stock at any point needed (with the stock decklid with no holes of course).
i'm not sure how much easier that is really going to be, but will let you know. keep up the good work. if you make it down to Atlanta, let me know so we can hook up.
|
|
#7
March 26th 2007, 05:20
|
||||
|
||||
|
Thanks Guys
Had been working on the bug yesterday afternoon. I was planning to make an hole new dash by myself. That plan I still have, but is set back for an couple years now because the budget (which budget  ?) don't let it.So I started making an temporary dash.   Besides the switches there also will be signallights. Wiebrand
__________________
B-Extreme B-Tuning..... Racebug is comming to get ya!!!
|
 |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Hybrid Mode
